How do I reset my Intel Desktop Board BIOS?

Steps to clear CMOS using the battery method

  1. Turn off all peripheral devices connected to the computer.
  2. Disconnect the power cord from the AC power source.
  3. Remove the computer cover.
  4. Find the battery on the board.
  5. Remove the battery:
  6. Wait 1–5 minutes, then reconnect the battery.
  7. Put the computer cover back on.

How do I get into Pentium 4 BIOS?

Press F2 during boot to enter the BIOS setup. Press F9 to set defaults. Press F10 to Save and Exit.

How do I bypass Intel BIOS password?

Clearing the password:

  1. Find the onboard configuration jumper.
  2. Move the configuration jumper to pins 2-3.
  3. Plug in the computer to the power source and power on the computer.
  4. The computer starts the setup program, and the Maintenance menu is displayed.
  5. Select Clear Passwords and press Enter.
  6. Select Yes and press Enter.

How do I change my Intel BIOS settings?

The BIOS setup program can be used to view and change the BIOS settings for the computer. To access the settings, press the F2 key after the Power-On Self-Test (POST) memory test begins and before the operating system boot starts.

How do you reset BIOS in Windows 10?

Performing a Factory Reset from BIOS (Microsoft Windows)

  1. Power on or restart the workstation.
  2. Enter the BIOS by tapping either the right or left bottom of the screen.
  3. Tap Advanced, and then tap Special Configuration.
  4. Tap Factory Recovery.
  5. Select Enabled from drop-down menu.
  6. Tap Home.
  7. Tap Save and Exit.

How do I bypass Intel boot agent?

To prevent the Intel Boot Agent (IBA) from initializing, use the Intel® Ethernet Flash Firmware Utility (BootUtil.exe) to turn it off. Intel Ethernet Flash Firmware Utility is a program that: Changes the default settings of your Intel® Ethernet Adapter. Enables or disables the Wake-on-LAN.

How do you reset the BIOS?

Reset the BIOS to Default Settings (BIOS)

  1. Access the BIOS Setup utility. See Accessing BIOS.
  2. Press the F9 key to automatically load the factory default settings.
  3. Confirm the changes by highlighting OK, then press Enter.
  4. To save the changes and exit the BIOS Setup utility, press the F10 key.