How many amps does a Rule 2000 bilge pump draw?
8.4 Amps
Port Size: 1-1/8″ (discharge outlet) Nominal Voltage: 12 Volt DC. Max. Current Draw: 8.4 Amps.
How do you connect a float switch to a bilge pump?
Connect one of the wires from the float switch to each of the switched terminals on the three-way switch. Reconnect the negative cable to the battery’s negative terminal. Flip the three-way switch into the “Off” position and listen for the bilge pump; it should remain off.
How many amps does a rule bilge pump draw?
Rule 360 Bilge Pump. 360 GPH – 23 Litres per minute. Compact – 89mm H x 61mm W. 12 volt DC – 2.1 amp draw.
Do you recommend an automatic bilge pump?
We do recommend an automatic bilge pump, but there is little justification for putting a switch on the “automatic” feed, and there is potential risk reduced by NOT putting the auto feed on a switch.
What is a manual bilge pump switch?
A Manual / Auto bilge switch, is an A-B switch with a center off position. There are two paths through it… one direct (bipassing the float), and one in series with the float switch (series means AND… both the auto switch AND the float switch must be closed for the pump to activate). In Most Cases, use an ON-OFF Switch
Does my boat need a bilge pump with float switch?
We DO recommend every boat have an automatic (float switch) feed for the bilge pump, BUT recommend the “auto” float switch lead be run directly from the boat’s battery (fused of course). Why an ON-OFF Bilge Switch with Float?
Can you connect a bilge pump directly to battery?
The reason typically cited to NOT connect devices straight to the battery is that a trickle current (like from a GPS, or VHF) could drain it. BUT, there is little to no risk of this when a device (like a bilge pump) is connected with a physical disconnect switch (like a float switch).