How do I reset my Zanussi washer dryer?
Resetting guide: Press the two buttons at the top (soak and pre-wash). At the same time, turn the cycle selector counter-clockwise to the delicate spin cycle. Then release the two buttons and continue turning the selector counter-clockwise all the way round to off (almost one full turn). Try to wash normally.
Can you repair a dryer heater element?
Fortunately, replacing a heating element isn’t a terribly difficult job. You can usually find a replacement heating element at a local hardware store or online by searching for your dryer model number. Once you have the part, unplug the dryer, remove the back panel, remove the connections and install the new one.
Why does my washing machine not heat up?
Make sure that the appliance is not overloaded. Determine whether the selected cycle involves heating. Ensure a heating temperature has been selected for the program. Make sure that the drain filter is clean and unclogged.
Why is my Zanussi tumble dryer not working?
If the appliance still shows no life, unplug the appliance again and check the fuse in the plug. If no method of checking the fuse exists replace it with a known working 13 Amp fuse. Then try the appliance again. If the appliance is still not working contact Authorised Service Center.
How do you clear a Zanussi error code?
Turn the dial to off. Press and hold together the start button (the one with the green arrow) and the button to the left of it. While holding, turn the Programme Dial 1 ‘click’ clockwise(to 90 degrees temp). The lights ( or digital screen ) will flash – release the buttons (the lights should scroll).
Where do I find my Zanussi error code?
Error codes on Zanussi washing machines will be displayed in two different ways. If your machine has an LCD display you’ll see the letter E (E is for Error) followed by two numbers. If your machine has no LCD display however, combinations of LEDs on your machine will flash.