How do I make my Cisco IP Phone stand up?

To adjust the footstand, push in the footstand adjustment button and adjust the tilt. You can secure the Cisco Unified IP Phone to a desktop by using a laptop cable lock. The lock connects to the security slot on the back of the phone, and the cable can be secured to a desktop.

How do you remove the stand on the back of a Cisco phone?

To remove the stand, adjust it so that is lays flat against the back bezel. There are two plastic pins that hold the stand to the phone. To release these two pins, use a knife (or some other thin edged object) to wedge in between the pin’s head and the plastic edging to pry the 2 pin heads towards each other.

How do I connect my Cisco IP phone to WiFi?


  1. Unplug the Ethernet cable and plug in the power adapter.
  2. Press Information and settings (gear icon).
  3. Navigate to Network Configuration.
  4. Select Wi-Fi configuration.
  5. Select the Service Set Identifier (SSID) of the network.
  6. Enter the network Passphrase/password.
  7. Press Connect.

Do Cisco phones have WiFi?

The Cisco Unified IP Phone 9971 exhibits Wi-Fi capabilities which can be used with 802.11a, 802.11b, and 802.11g Wi-Fi. The following figure shows a typical WLAN topology that enables the wireless transmission of voice for wireless IP telephony.

How do I connect my Cisco 8861 to WiFi?

How do I verify my network connection on my Cisco phone?

Verifying Wireless Settings On Cisco Wireless IP Phone 7920, you can view information about the current wireless network settings of the phone to troubleshoot problems. Step 1 Choose Menu > Network Config > 802.11b Configuration. Step 2 Scroll to the desired 802.11b Configuration setting and press Select.

How to setup Cisco IP phone 7941 to do SIP?

Configure the SIP extension in Asterisk. Now you need to configure the SIP extension in Asterisk. Do this as per any other SIP extension, but bear this important piece of information in mind: The Cisco 7941 can only deal with 8 character passwords, so keep your SIP authentication secret to 8 characters.

How to find the IP address on a Cisco phone?

Objective. The objective of this article is to provide the necessary steps for finding the IP address of a Cisco 6800 Series Phone.

  • Applicable Devices
  • Software Version
  • Introduction. Cisco IP phones have been made to match your needs.
  • Overview of the Phone. Note: The image shown is the Cisco IP Phone 6841 Model.
  • Determine the IP Address of the Phone.
  • How to use your Cisco IP phone?

    Cisco IP Phone, allowing you to place, receive, and otherwise handle calls. If you install Cisco IP Communicator on a laptop or portable computer, you can use Cisco IP Communicator (and all of your phone services and settings) from any location where you can connect to the corporate network.

    How to reset Cisco phone?

    Power off the phone (if using inline power,just remove the ethernet).

  • Hold the#key down.
  • Power on the phone while still holding down the#key.
  • When the line buttons scroll down orange,you can take your finger off the hash button
  • Press the following buttons: 3491672850*#
  • The line buttons should continue to scroll,but now they should be red