Who made Pinnock sewing machines?

The factory was officially opened by Sir Thomas Playford on 1st November 1957. Within a few years the company was employing 50 workers. Motors for the machines were made by Wernard. During 1961/62 the company established a small assembly plant near Wellington, New Zealand.

Where are Pinnock sewing machines made?

In 1957 the company relocated to a new purpose built factory in the new city of Elizabeth which was being established about 17 miles north of Adelaide, South Australia. The factory was officlally opened by Thomas Playford on 1st November 1957.

What are the parts of mini sewing machine?

Mini sewing machine parts ─ front view

  • Upper thread bobbin. In a regular sewing machine, a spool of thread sits on top.
  • Thread tension screw.
  • Three purple buttons.
  • Cuff slot.
  • Hand wheel.
  • Foot pedal port.
  • DC power port.
  • Take-up lever.

What are the 10 parts of sewing machine?

Functions of each sewing machine parts have discussed below:

  • Spool pin: The main function of the spool pin is to hold the spool of thread.
  • Bobbin binder spindle:
  • Bobbin winder stopper:
  • Stitch width dial:
  • Pattern selector dial:
  • Handwheel:
  • Stitch length dial:
  • Reverse stitch lever:

What are the 14 parts of sewing machine?

Which should be the first step in threading the lower parts of sewing machine?

How to Thread a Sewing Machine

  1. Wind a bobbin. The bobbin is the lower spool of thread for your machine.
  2. Load your wound bobbin.
  3. Place the spool.
  4. Thread through the thread guide.
  5. Pull the thread through the U-shaped guide.
  6. Wrap the thread around the thread take-up lever.
  7. Thread the needle.
  8. Catch the thread.

Why should you put the presser foot down while sewing?

If the presser foot tension is set correctly, your stitches are of the same length and the fabric slides through easily without the need to be pulled, pushed or guided through. If there’s too much pressure put down on the presser foot (presser foot too low), your fabric will pucker.

What are the 20 parts of a sewing machine?

What is needle bar?

Definition of needlebar : a bar on a sewing or knitting machine for holding the needle or needles.

What are the 3 parts of sewing machine?


  • Spool pin: Holds a spool of thread.
  • Bobbin winder spindle: Bobbin is placed here during winding.
  • Bobbin winder stopper: Stops winding the bobbin when it reaches capacity.
  • Stitch width dial: Controls the width your stitch.