How do you use VAX pre treatment solution?
Simply put Vax Pre-treatment Solution in the clean water tank, plug in the wand, turn on machine and it will produce a fine spray to put on the mess. Leave this on your carpet for 15 minutes and then begin your full carpet wash. Remember when it comes to stains, time is of the essence.
Do you put warm or cold water in a Vax carpet cleaner?
Have a quick vacuum around the area before you begin carpet washing to remove any surface debris, as this will help prevent your carpet cleaner from getting clogged. Fill the clean water tank on your carpet cleaner with warm water (max 40oc) and cleaning solution.
How do you use a VAX Rapide spring clean?
Tilt the solution reservoir away from the cleaner and remove. Unscrew the cap from the back of the solution reservoir. Pour the correct amount of Vax Solution as directed on the solution label into the clean water tank. IMPORTANT: Turn o when emptying and lling the tanks and performing any maintenance.
How much VAX solution do I need?
The Vax Ultra+ bottle recommends 40 ml per litre of water. The cap on the fresh water tank of my machine holds approximately 30 ml. I use four capfuls and add this and three litres of water to the fresh water tank.
Do you need to rinse carpet after shampooing?
Children’s Mercy Hospital Environmental Health Program recommends rinsing carpets after cleaning to remove any chemicals in the carpet cleaning solution and to keep the carpet clean in the future. Detergent left behind in the carpet fibers can attract dirt and cause the carpet to become dirty much faster than normal.
Can I use washing up liquid in a carpet cleaner?
Washing-up liquid was found to be as effective as specific carpet cleaners when removing blood, Ribena and wine stains. “Which? tests have revealed that ordinary washing-up liquid outperforms many carpet stain removers,” said the magazine.
Why won’t my carpet cleaner pick up water?
Your carpet cleaner might think its filter is too clogged for you to continue cleaning and will stop. This could be the reason for the suction problem. The filter might also be too blocked for the unit to be able to suck. This is because the water will not be able to pass through the machine and cause a backlog.